Philips SDV9011K/17 Manuel D'utilisateur page 7

Assembly
• Insert VHF Boom-B into VHF Boom-A and secure using 1-1/2˝
screw and lock washers. Repeat steps for 2nd boom as well.
• Attach tubing brace to rear of VHF Boom with 1-1/2˝ screws
and wing-nuts.
• Slide UHF Boom through center slot of VHF Boom support
block until hole A of UHF Boom aligns with hole B of VHF
Boom. Secure with 1-1/2˝ screw and wing-nut.
• Attach phasing wire and lead-in wire to UHF antenna using
3/4˝ screws, washers, and wing-nuts.
• Insert end caps at ends of all booms.
Mast Assembly (Mast not included)
• Assemble U-bolts to cross pieces.
• Use saddle on center of boom.
• Assemble U-bolt assemblies loosely to antenna.
• Insert mast through U-bolts.
• Tighten U-bolts securely. All U-bolts should be on one side
of mast.
• Attach mast standoff to mast.
• Insert wire in standoff and tighten with pliers.
• Power lines should be as far away as possible.
• Assemble U-bolts in wall mounts with lock washers and nuts.
• Secure mounts to wall with wood screws.
• Separate mounts by at least two feet.
• Insert mast with assembled antenna through both U-bolts.
• Face antenna toward TV station.
• Tighten U-bolts securely.
• Wall mounts and chimney mounts are not included.
EN
7