ZIBRO CLIMA P80 Manuel D'utilisation page 49

4
Fan speed
Select with the fan speed:
5
Temperature selection
Set the temperature that must be maintained (in the range from 16°C to 30°C)
with switched and
6
Digital display
When the unit is ON the display shows the room temperature (
or to see the set temperature (
room temperature will again be displayed.
7
'SLEEP' setting
This setting can only be used when the cooling function is activated. Press
Every hour the temperature setpoint will raise with 1°C, after 2 hours the
temperature remains the same. After 12 hours the air-conditioner will
automatically turn off. Pressing
mode the temperature set cannot be changed.
Remote control
The air conditioner can be operated with remote control. Two AAA-batteries are
required to use the remote control.
NOTICES!
The compressor has been set so that it starts functioning three minutes after the
(re)start of the air conditioner.
The cooling will switch off when the room temperature is lower than the set one.
Ventilation will however continue to work on the set level. When the room tem-
perature rises above the selected value, the cooling will work again.
low, high. LED will show this.
. The display will show the setting.
is on), after a few of seconds the
again de-activates this function. In 'SLEEP'-
is on). Use
.
4
49