Important Information - DURAVIT OpenSpace 770001 Notice De Montage

Important information

Regarding the mounting instructions
These mounting instructions comes as part of the Duravit
shower enclosure and should be read carefully prior to
installation.
Explanation of the key words and symbols
ADVICE! In the case of potential damage to property
Link to the installation information in this
section
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Target group and qualification
The shower enclosure must only be installed by trained
plumbing engineers.
NOTE!
Local installation regulations and any country­specific
standards must be observed at all times.
Installation information
Please read the pre­installation data sheets prior to
the installation. These are available to download on the
Internet at www.duravit.com.
1
Checking the surfaces (Diagram 1)
> Check the surfaces for scratches and damage
after unpacking and removing the protective film.
> Always place the cardboard underneath after
unpacking to protect the surfaces from any
damage.
3
Observe the tolerance compensation (Diagram 3)
> For a trouble­free installation, position the
template onto the neutral point on the wall with
some clearance, if necessary.
> Washers are included to adjust the height of the
wall profiles in order to raise them as required.
6 8
+ Fixing the profiles in place (Diagrams 6+8)
> Adjust the fixing to the structural conditions.
11
Observe the width of the profile (Diagram 11)
> Mount the wider profile onto the wall on which the
fitting is located.
45
Observe the installation area (Diagram 45)
> Observe the area for installing the fitting in
accordance with the drawings (Pages 32 and 33,
grey marking corresponds to where the fitting
should be installed).
5
DA_M_OpenSpace/13.10.5