BiAL ILS Mode D'emploi page 14

Operation
Heating power regulation
Pressing the button
vice, after which, the element will begin to
heat. By turning itself on and off regularly,
the device regulates the heating output of
the radiator to an average output, as set by
the user within 30-100% of nominal heating
output of the device.
The design of the device (PTC heating el-
ement) protects the user from harm via
burning, by automatically limiting radiator
temperature to 60° C , regardless of the cur-
rent setting (provided that the heat output
of the element has been correctly matched
with the heat output of the radiator).
The design of the device as well as physical
characteristics of heating medium inside
the radiator influence the way in which heat
is distributed throughout radiator — tem-
perature of the pipes at the bottom of the
radiator (especially the two located at the
very bottom of it), may be lower than the
temperature of the remaining parts of the
radiator — this is a normal phenomenon.
14
2h dryer mode
Power on/off
switches on the de-
Setting of required heating output:
In order to obtain the required room tem-
perature, please set the right heating level
of the device (buttons / ). It is possible to
set 1 of 5 heating levels: 30-40-60-80-100%
of the nominal heating output.
Selection of every subsequent level is indi-
cated by switching on subsequent diodes.
TIMER Function
TIMER function allows programming of
the device to heat for 2 hours with a dif-
ferent heat output, for instance in order to
dry a towel. After this period of time the
device automatically returns to the setting
from before the 2-hour dryer activation.
TIMER is turned on by pressing the
ton (also when the device is off). The de-
vice will start working with the heat output
but-