Publicité
Les langues disponibles
Les langues disponibles
Mailbox Solution Components:
(1) Cast Stone Post
(1) Cast Stone Post Cap
Materials and Tools Required:
Ready to mix concrete
•
• Tape measure
Hammer
• Phillips screw driver
Step 1. Dig a hole 8" in diameter approximately 24" - 36" deep.* Review USPS mailbox requirement from the curb.**
Step 2. Determine the height of the 4" x 4" wooden post by adding the depth of the hole plus 50". Mark wooden post
accordingly and cut off excess material with a saw.
Step 3. Place the 4" x 4" wooden post in the hole and gently tap the top of the post with a hammer to secure the
post in the ground.
Step 4: Mix concrete to manufacturer's recommendations and pour evenly around the post to the top of the hole.
Use a level to make sure the post is straight and secure until concrete sets.
Step 5: Slide the cast stone mailbox post over the 4" x 4" wooden post. Position cast stone post flush to the ground
and flush to the middle of the wooden post facing the street.
Step 6: Double sided construction grade tape is pre-installed for securing the curved support leg to the bottom of the
support shelf. Remove the protective plastic on the double sided tape and attach the leg by pressing it onto
the tape. The curved leg must be placed into the recess so the bottom of the leg with the hole is facing the
side for mounting.
Step 7: Depending on mailbox size (not included), either standard or oversized, the mailbox
support platform should be positioned between 38" to 43" high** from the ground.
Center the mailbox support on the cast stone post and drill through the pre-drilled
holes on the mailbox support and through the cast stone column, and into the wooden
post using a 9/64 masonry bit. Secure with three #10 screws.
Step 8: Further secure the mailbox support arm by drilling another hole at the bottom through
the pre-drilled hole and through the cast stone column, and into the wooden post.
Secure with one #10 screw. Use manual screwdriver for final seating of screw.
Step 9: Apply clear caulk to top of the cast stone post and secure the mailbox cap.
Step 10: To install the mailbox onto the mailbox support platform, follow the mailbox manufacturer's installation
instructions.
IMPORTANT NOTES:
*Before digging, check for underground utilities. The North American One Call Referral Service at 1.888.258.0808 connects
you to a national directory of utility companies.
**The United States Postal Service requires mailboxes to be installed with the bottom of the box at a vertical height of
between 3-1/2 to 4 feet from the road surface and 6 to 8 inches from the front face of the curb to the mailbox door.
Questions? Contact your local Eye Level Dealer or Eye Level Customer Service at 888.782.1760, option 3.
Installation Instructions
Cast Stone Mailbox Post
• (1) Mailbox Support
• (4) 3" Zinc Plated #10 Flathead Wood Screws
• One 8' 4"x4" pressure treated wooden post
• Drill
• Level
• Caulk (Clear)
2
English
• Shovel or post hole digger
• Masonry drill bit 9/64
• Saw
Mailbox Support
ELCMBPII 05-10
Publicité
