Cleaning And Maintenance; Cleaning The Machine - Linea DOMO DO236SW Mode D'emploi

USE
1. Press the on/off button to turn the appliance on. When you turn the appliance on, the rollers in
the cleaning head will start rotating. The indicator light will illuminate to show the appliance is in
operation.
2. Press the speed controller to adjust the speed.
3. Hold down the water spray button to pump water into the cleaning head. This will wet the roller so
that it can be used to clean the floor.
4. Press the on/off button again to turn off the appliance.
· When the waste water tank has reached its maximum level, the indicator light will flash and the
appliance will turn itself off eventually. Empty and clean the tank before continuing to use the
appliance.
· The appliance is equipped with a safety device that will ensure the appliance switches itself off, for
example, if large objects or fingers get into the cleaning head. This is for personal safety and to protect
the motor. To rewind the rollers, press the power button again.
· Do not use the appliance on carpet.
· After use, place the appliance in its storage base.

CLEANING AND MAINTENANCE

CLEANING THE MACHINE

Wipe the appliance and the storage base down with a damp cloth and dry thoroughly. Never submerge
the appliance or the storage base in water.
CLEANING THE CLEANING HEAD (ROLLERS)
1. Remove the nozzle cover. To do this, gently pull the top of the cover in the middle.
2. Lift the roller on the left-hand side to remove it from the nozzle. Clean the cleaning head with a
damp cloth and then dry.
3. Cut or clip off any jammed hairs around the roller and remove as much dirt as possible from the
roller.
4. Use warm water and a mild detergent to wash the roller and the nozzle cover. Leave to dry
thoroughly.
5. Place the roller back into the nozzle. Slide the right-hand side into place first and then press the left
side until you hear a click. Then place the cover back on the nozzle. First, hold the cover in front of
the roller in a horizontal position and then click it into place in a vertical movement. You will hear a
click when it is positioned correctly.
Note: Make sure the parts are correctly assembled. If they are not properly assembled in the appliance,
the appliance will make a strange noise. If this happens, switch off the appliance immediately and
reassemble the parts.
34
DO236SW
1 2 4 5