PCM GSE-3407-HP Mode D'emploi page 2

English
1. To fix the tool holder to the machine,
introduce the shank and then tighten
the 2 screws of fixations (Important,
watch that the screws have the
same strength of tightening).
2. Adjust the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSE-3407-HP
3. During the mounting or the dismounting
of your cutting tools, block the broach
on flats planned for that purpose, using
an adapted wrench.
4. The tool shank diameter should never
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
MARK :
-
-
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation :15.02.17
Never use the tool holder with empty
positions. Use the supplied
protection plug.
Never use the tool holder without
the internal coolant.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email: office@pcm.ch
Document :
GSE-3407-HP
Mode d'emploi 1-
Page : 2 de 4