CV1004
If the motor stops, switch off the vacuum cleaner and proceed as follows:
➤ Check whether the suction hose is blocked.
Hold the suction hose up and drop a small coin in from above. If the coin
does not fall through the hose, it is blocked. Push the dirt ball through the
hose using a long rod.
➤ Check the dust bag.
If a large amount of dirt which is not household dust (plasterboard dust,
fine sawdust etc.) is vacuumed up, the pores in the dust bag can get
blocked.
Insert a new dust bag.
➤ Clean the suction hose if it is heavily soiled.
– Hold the ends of the suction hose up high.
– Pour liquid detergent into both ends.
– Fill up with water while holding both ends up.
– Shake the suction hose to and fro to loosen the dirt.
– Pull the suction hose apart as far as possible.
– Rinse out the dirt.
– Repeat this procedure until the suction hose is clean.
– Hang the suction hose up from the middle and leave it to dry before
using it again.
➤ Check whether the floor nozzle is blocked.
Clean the floor nozzle.
➤ Check the motor filter.
Clean or replace the motor filter.
11
Warranty
The statutory warranty period applies. If the product is defective, please
contact the manufacturer's branch in your country (see the back of the
instruction manual for the addresses) or your retailer.
For repair and guarantee processing, please include the following docu-
ments when you send in the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
EN
Warranty
17