Thitronik Pro-finder Instructions De Service Et De Montage page 30

Pro-finder Manual
2.1 Explanation of the messages received
Depending on the type of incident and setting of the program select switch, an SMS
can contain the following information:
Reception: The more negative the displayed value, the better the reception.
GPS: Stand by The GPS receiver is in stand by mode. It will be automatically
reactivated if there is an event.
UTC: Time of the incident (indicated in coordinated universal time)
Pos: Current position of the vehicle
Speed: Current speed of the vehicle
Credit balance: Current credit on the SIM card (only for pre-paid cards)
The message length is limited to 160 characters. Depending on the
message content the credit may not be included. In this case send a
message with the text POS to Pro-finder to receive the remaining
credit.
Status report: You receive this message only on request, as described in chapter 2.3,
or at intervals, depending on the selected mode. In addition to position, speed and states
of the outputs, depending on the mode, supplemental information on voltages U2 – U5,
as well as the temperature in the immediate vicinity of the device, are also included in
the status report.
Theft alert: You receive this message if WiPro is armed and your vehicle is further than
approx. 1500 m from the original location. A theft alert is a silent alert. This means that
neither the flashers nor the siren are activated. Both of these can be activated via SMS
as described in chapter 2.2.
Voltage warning (not in operating mode B): If the power supply permanently drops
below 11.2 V, Pro-finder switches to stand by mode to save battery power. In this case
an SMS with the voltage level is sent. When the voltage rises above 12.5 V again the unit
switches back to normal operation.
Page 10