Installation - Brandt WD1014X Guide D'utilisation

EN

INSTALLATION

Before connecting the appliance to the power supply, check that the
wires of your electric installation have sufficient diameter to supply
power to the appliance during normal use. The fuse for the installation
should be 10 amps.
It is necessary to provide a bipolar cut-off device in the power supply circuit,
with an open contact gap of more than 3 mm
.
The electric connection should be made before the appliance is installed in
the cabinet.
The drawer should be connected by a (standard) power cord with three 1
mm² wires (1 single phase + 1 N + ground) to the 220-240 V single phase
power supply via an electric circuit corresponding to the CEI 60083 standard
or complying with the installation rules. The protective wire (green/yellow)
corresponds to ground on the appliance and should be connected to the
ground of the installation.
In the case of a connection via an electric outlet, the outlet should be
accessible even with the appliance installed.
The neutral on the heating drawer (blue wire) should be connected to neutral
on the power supply.
16