Safety Precautions - BasicXL BXL-FA10 Mode D'emploi

Flying Alarm Clock
ATTENTION!
Please make sure the adapter is correctly plugged into the clock. Check the polarity of both
connections before connecting.
Instructions Flying Alarm Clock
1. Carefully remove the propeller from the plastic bag.
2. Carefully remove the ball from the plastic bag.
3. Connect the two parts by placing the propeller firmly on the square end of the ball.
4. Connect the other end of the ball to the main base.
5. The clock is now ready for take-off.
Setting the time, alarm and snooze features:
1. Time and clock setting:
Hold the TIME button and push the HR button at the same time to CHANGE the hour settings.
To set the minutes, hold the TIME button and push the MIN button.
2. Alarm setting:
Hold the ALARM button and push the HR/MIN buttons at the same time, until the desired alarm
time is set.
3. AL-SZ-OFF-functions:
To active the alarm, the AL-SZ-OFF-button must be set to AL. Set the switch to SZ for snooze
function. This is a continuous alarm that will ring every seven minutes for the next hour. Push OFF
to shut the alarm down.
(When the alarm starts ringing, the propeller will take off from the base. To switch off the alarm, the
propeller must be put back on its base.)
4. Warning:
Do not use rechargeable or old batteries.

Safety precautions:

Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
Keep this manual and packaging for future reference.
ENGLISH
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is
required. Disconnect the product from mains and other
equipment if a problem should occur. Do not expose the
product to water or moisture.
2