Before Use - König Electronic SEC-DVRTOR10 Mode D'emploi

5. Photo function
6. ON/OFF and video button
7. LED light ON/OFF
8. LED light
9. Camera lens
10. Windshield bracket
11. Bicycle bracket

Before use:

1) Open the cover at the bottom of the torch and insert a Micro SD card.
Connect the torch to a computer or notebook with the USB cable to
charge the battery. Be sure the torch is switched off before charging. The
indicator lights up blue for a moment and then starts to flash red. When
the torch is charged, the indicator remains red. It is recommended to
always charge the battery completely. The complete charging process is
about 6 hours.
2) Set the date and time. Be sure the torch is
still connected to a computer or notebook.
Select in the window "open folder to view
files". Create a text file in the folder. The text
file must be tagged and enter the current date
(YYYYMMDD) and time (HHMMSS). The
date in the record files will be shown as
MM/DD/YYYY HH/MM/SS. Save the file.
(Please type the time setting according to the
picture on the right.)
3) Disconnect the torch safely from your
computer or notebook. When the torch is
powered on again, the new date and time will
take effect. The text file will be deleted from
the folder. Close the cover before you
proceed with next step.
How to use the LED torch with camera:
Flashlight
Press the LED light ON/OFF to switch the 8 bright white LED's on and off.
Video function
Push the ON/OFF button for a few seconds until the blue indicator becomes red.
The camera is in standby mode and ready for use. Press the ON/OFF button quickly again to
start video recording. The blue indicator flashes with an interval of ± 1 second. To stop
recording, press the ON/OFF button again. The blue indicator flashes 3 times and goes off.
The red indicator remains on.
3