URBANGLIDE RIDE AR 2 Notice Originale page 22

Charging and powering
Remove the rubber cap, insert the charger into the charging port of your scooter. Once charged, replace
the cap and make sure it is on tightly.
When charging your scooter, make sure that the charging port is in good condition and that no residue is
stuck in it. If it is, clean it with a dry cloth. Use the charger supplied with the product, and only that
charger. If you have lost your charger, or it is faulty, contact Urbanglide support. Once the charger shows a
green light, unplug your product. Do not leave the charger plugged in for too long after charging is
complete.
Translated with www.DeepL.com/Translator (free version)
Your device is charging. Please wait until the colour changes.
When your device is charged, unplug it and the charger from
its power source.
9