Pre-Installation Preparation; Appliance Placement; Clearance To Combustibles - Timberwolf T2250 Instructions D'installation Et D'opération

3.0 PRE-INSTALLATION PREPARATION

3.1

APPLIANCE PLACEMENT

Have an authorized dealer install the appliance. If you install the appliance yourself, have your dealer review
your installation plans and/or installation.
Draw out a detailed plan of the installation including dimensions and verify the dimensions with the require-
ments listed in this manual.
You may wish to adjust the appliance position slightly to ensure the vent does not intersect with a framing
member. Appliance must be positioned so that no combustibles are within, or can swing within (e.g. drapes,
doors), 48" (1219.2mm) of the front of the appliance.
3.2

CLEARANCE TO COMBUSTIBLES

DO NOT INSTALL INTO ANY AREA HAVING A HEIGHT LESS THAN 7 FEET (2.1m)
(CEILING OF ENCLOSURE TO APPLIANCE BOTTOM, EXCLUDING HEARTH HEIGHT).
PARALLEL & CORNER
SIDEWALL (A)
SIDEWALL TO FLUE (B)
BACKWALL (C)
BACKWALL TO FLUE (D)
CORNER (E)
CEILING (F)
Clearances can be reduced with shielding acceptable to local authorities. Reduced installation must comply
with NFPA 211 or CAN/CSA-B365.
BACK WALL
D C
A
B
SINGLE WALL CONNECTOR
T2250
12" (304.8 mm)
21" (533.4 mm)
12" (304.8 mm)
16.5" (419.1 mm)
6" (152.4 mm)
84" (2133.6 mm)
WARNING
!
BACK WALL
E
E
67.1B
F
DOUBLE WALL CONNECTOR
T2250
10" (254 mm)
19" (482.6 mm)
6" (152.4 mm)
9" (228.6 mm)
4" (101.6 mm)
84" (2133.6 mm)
W415-1212 / 05.13.13
45
EN