Imetec ECO COMPACT Mode D'emploi page 13

not tamper with it. Any repairs must only be carried out by an
authorised technical service centre.
• The iron must be used on a stable surface. When the iron is placed
on the iron rest, make sure the support is stable. The iron must not
be used if it has been dropped, if it is visibly damaged or if it leaks
water.
• If the power cable is damaged it must be replaced by an authorised
technical service centre, so as to prevent all risks.
• The electrical safety of this appliance is only guaranteed when it
is connected correctly to an effective earthing system as required
by applicable electrical safety standards. This important safety
requirement must be verified and, if in doubt, request a thorough
check of the system by a qualified technician.
• The plug must be unplugged before the reservoir is filled.
Do NOT immerse the iron, the power cord or the plug in any
kind of liquid.
DO NOT leave the hot iron in contact with easily flammable
fabric.
DO NOT leave the iron unattended when connected to the
power supply.
DO NOT dispense steam when the iron is resting on its
mat.
ATTENTION! Hot surface.
DO NOT use chemical additives, scented substances or
descaling agents.
EN
11