Transducer Orientation And Fish Arches - Navico Eagle CUDA 300 Mode D'emploi

Bolt
Attach motor mounting bracket to transducer.
3. Route the transducer cable alongside the trolling motor shaft. Use
plastic ties (not included) to attach the transducer cable to the troll-
ing motor shaft. Make sure there is enough slack in the cable for the
motor to turn freely. Route the cable to the sonar unit and the trans-
ducer is ready for use.
Transducer mounted on trolling motor, side view.

Transducer Orientation and Fish Arches

If you do not get good fish arches on your display, it could be because
the transducer is not parallel with the ground when the boat is at rest
in the water or at slow trolling speeds.
Internal tooth washer
Nut
Flat washer
11
TMB-S bracket