Before Using For The First Time - Lagostina Savoy Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Never disconnect the plug by pulling on the power cord.
• Any intervention other than normal cleaning and maintenance by the customer must be performed by an Approved
Service Centre.
• All appliances are subject to strict quality control procedures. These include actual usage tests on randomly selected
appliances, which would explain any traces of use.
• Never use scouring pads for cleaning purposes.
• To remove the scale filter, remove the kettle from its base and leave it to cool down. Do not remove the filter when the
appliance is filled with hot water.
• Do not use any method to descale the kettle other than that recommended.
• Keep the kettle and its power cord away from any source of heat, from any wet or slippery surface and away from
sharp edges.
• Never use the appliance in a bathroom or close to a water source.
• Never use the kettle when your hands or feet are wet.
• Always unplug the power cord immediately if you observe any anomaly during operation.
• Never pull on the power cord to remove it from the wall socket.
• Always remain vigilant when the appliance is on, and in particular be careful of the steam coming out of the spout
which is very hot.
• Never leave the power cord hanging from a table top or kitchen counter to avoid any danger of it falling to the floor.
• Never touch the filter or the lid when the water is boiling.
• Also be careful as the body of stainless steel kettles becomes very hot during operation. Only touch the handle of the
kettle.
• Never move the kettle when it is in operation.
• Protect the appliance from damp and freezing conditions.
• Always use the filter and the lid during heating cycles.
• Never heat the kettle when it is empty.
• Place the kettle and its power cord well to the back of the work surface.
• The guarantee covers manufacturing defects and domestic use only. Any breakage or damage resulting from a failure
to comply with these instructions for use is not covered by the guarantee.
Description
A : Base
B : Kettle
C : Spout
D : Filter
1) Remove all of the various packaging, stickers or accessories from both the inside and outside of the kettle.
2) Adjust the length of the cord by winding it under the base. Wedge the cord into the notch (Fig. 1).
Throw away the water from the first two/three uses as it may contain dust. Rinse the kettle and the filter separately.
Use
1) FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER (Fig. 3)
• Never fill the kettle when it is on its base.
• Do not fill it above the maximum level, or below the minimum level. If the kettle is too full, boiling water may spill out.
• Do not use without water.
• Check that the lid is closed properly before use.
2) POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE MAINS SOCKET
3) TO START THE KETTLE
Press the on/off button positioned on the bottom of the handle (Fig. 4).
4) THE KETTLE WILL SWITCH OFF AUTOMATICALLY
as soon as the water reaches boiling point. You can stop it manually, before removing it from its base to pour the water.
The indicator light will go out when the water reaches boiling point. Make sure that the on/off button is in the off
position after boiling and that the kettle has switched off before removing it from its base.
• Do not leave water in the kettle after use as this quickens the formation of scale.
6
E : Lid
F : Handle
G : Water lever indicator
H : On/Off switch

Before using for the first time

Publicité

Table des Matières
loading

Table des Matières