Part List - Kenwood CX-DAB1 Manuel D'installation

CAUTION
■
Disconnect the battery's negative terminal
and make all electrical connections before
installing the unit.
■
Mounting and wiring this product requires
skills and experience. For safety's sake, leave
this work to professionals. If you experience
problems during installation, consult your
Kenwood dealer.
■
This film antenna is exclusively for use inside
the vehicle.
■
Do not install at the following locations:
– Where it may block driver's view
– Where it may obstruct operation of safety
devices such as air bags
– On movable glass surface such as rear
hatch
■ Signal strength will decrease at the following
locations:
– On IR reflecting glass or where covered
with mirror type glass film
– Where it overlaps with genuine radio
antenna (pattern)
– Where it overlaps with window heating
wires
– At side of vehicle (e.g. door, front quarter
window)
– On rear window
– When glass that blocks radio signals (e.g.
IR reflecting glass, thermal insulation glass)
is used
– Reception may decrease due to noise
when windshield wiper, air conditioner, or
motor is turned on.
– Reception may decrease depending on
the direction of the broadcast station with
respect to the vehicle (antenna).
■
Be sure to check the installation location
of film antenna A before installing. Film
antenna cannot be re-pasted.
■
Thoroughly wipe oil and dirt from the
pasting surface with the included cleaner D.
Do not bend or damage the film antenna A.
■
■ Warm the pasting surface by turning on the
heater for example, before applying.
2
|
English
■
It may not be possible to install on some
type of vehicle.
■
Check the cable routing of the film antenna
A and amplifier B before pasting.

Part list

A .......................... DAB antenna film (×1)
B .............. DAB antenna amplifier (×1)
C ...................................Cord clamper (×3)
D .................................................Cleaner (×1)
Specifications
Frequency Range: 170
Impedance: 50Ω
Operating voltage: 9
Current Consumption: 70mA (Max)
Connector Type: SMB
Cable Length: 3.5m
• Specifications subject to change without
notice.
–
240MHz,
–
1452 1492MHz
–
16V