Usage; Tips To Ensure A Better Milk Flow - Beurer BY 70 Mode D'emploi

2. Insert the silicone tubes for two-sided pumping into
the 2 pump attachments and the breast pumps
3. For one-sided pumping, insert the silicone tube with-
out adapter into the pump attachment and the breast
pump.
4. Connect the breast pump to the mains cable and in-
sert the mains plug into the socket.
5. If you instead choose to operate the breast pump
using batteries, open the battery compartment cov-
er on the rear side of the motor unit. Insert four AA
batteries (included in delivery). Make sure that the
batteries are inserted the correct way round. See
the graphic in the battery compartment. Next, close
the battery compartment until you can hear and feel
it click into place. A single battery charge with four
new AA batteries will last for approximately 60 min-
utes of operation (at the lowest setting).

7. Usage

7.1 Tips to ensure a better milk flow

• Choose a location to use the pump where you can relax.
• Choose a time to use the pump when you can relax.
• Having your child nearby or looking at a picture of your child can have a positive effect on the milk flow.
• If feeding your child using one breast, use the breast pump on the other breast at the same time.
• Warmth and relaxation encourage milk flow. Use the breast pump after having a shower or bath.
• If your breasts are swollen or sore, place a warm towel on them for a few minutes. This will improve the
milk flow.
• If the milk does not start to flow from your breasts immediately, try to relax and then try again a few min-
utes later.
• If the breast pump still does not extract any milk from your breasts after five minutes, stop using it and
try again later.
• If you experience any sharp pains when using the breast pump, consult a doctor.
26