Bimar SE1600.EU Notice D'instruction page 9

Fax +32 030 9904733
I
•
f the electric cord is damaged, it has to be replaced by the supplier or an authorized service center
or a professionally qualified, to avoid any risks.
T
•
he appliance must not be positioned immediately under a socket.
D
•
o not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly. Check that no other high absorption appliances are connected to the same
power source.
INSTALLATION
• After removing the packing materials, check the integrity of the appliance; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger; but dispose of them in accordance with current law.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity and that the electric plug is grounded. In the event of incompatibility between the
electric outlet and the plug of the appliance, have the outlet replaced with another more suitable
type by professionally qualified personnel, who will make sure that the section of the wires of the
outlet is appropriate for the absorbed power of the appliance. In general, the use of adapters or
extension cords is not recommended; if their use is indispensable, they must conform to existing
safety standards and their current capacity (amperes) must not be less that the maximum of the
appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Position the heater:
- on a stable, flat (because the appliance could tip over) and smooth support surface.
- far from other sources of heat, inflammable materials (curtains, carpets, etc.), inflammable gases
or explosive materials (spray cans) and from materials that can deform on exposure to heat.
- 150cm away from walls and at least 100 cm from the ceiling: if the heater is located under a
patio, make sure that the patio roof will not be damaged or catch fire from the heat.
- far from ponds or swimming pools, etc., to avoid electrical shock or the appliance falling in: if
this should happen, first remove the plug from the socket, then raise the appliance and dry it
perfectly before turning it on again (if in doubt, have it checked by professionally qualified
personnel).
- far from places where it could be hit.
• Make sure that the cable is correctly positioned, that it is not touching hot elements or sharp edges,
is not wound around the utensil, is not twisted up on itself or in the way to prevent the utensil from
being pulled over. Check that you cannot trip over to prevent accidental falls or harm to persons.
• All repairs should be made by a competent qualified electrician. In any case you should return the
appliance to this service.
ASSEMBLY
Warning: the heater may only be used if completely and correctly assembled, so with base and
table. In case of doubt, to check or perform the operation by qualified personnel.
For the assembly is taken as a reference figure 1.
1) Insert the bottom of the body, platelets (2) into its seat.
2) Connect the body (1) behind (3) and the counterweight (4) by inserting in its place, with the two
screws (6) and 2 washers (5) provided.
3) Attach to the table (9) the brackets "L" (11), with the two screws (10) and (12).
4) Insert the table on the body and fasten with the screws (13).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
9/28
Assembly page 9/28