Wifi Configure Network - Norsup WIFI MODULE Notice Originale

WIFI MODULE
8

WIFI CONFIGURE NETWORK

1. Follow the instructions on the 3. Jump to system settings, connect
specified WIFI, click 14 to select
page (Fig.7), press button on
module and hold for 1s till two the "Smart_AP_xxx", click 15 to
lights on, then AP connection popup window(Fig.10), follow the
is activated, click 10 to confirm, instruction and then jump to WIFI
click 11 to turn the page; setting interface (Fig.11);
2. Click 12 to enter the WIFI
password for the current
connection, click 13 to confirm;
Fig. 7 Fig. 8
WIFI Module On interface Enter password interface
Fig. 10 Fig. 11
Setting interface WIFI setting interface
8 WWW.NORSUP.EU
Fig. 9
Connect specified WIFI
Fig. 12
Connect specified WIFI
Alterations which serve the technological progress as well as errors excepted!
WIFI MODULE
4. Slide the page back to configure 6. After WIFI and DTU bonding
network interface (Fig. 12), click 16
is done, and jump back to
to join WLAN Network, click 17 to My Device (Fig. 17).
cancel, click 18 to turn next page(Fig.
13); click 19 to bond device (Fig. 14);
5. Click "OK" to allow this APP to use
the camera for scanning the barcode
on heat pump unit (Fig.15); click
"OK", device bond is done (Fig.16);
Fig. 13 Fig. 14
Configure Network Bond Device
interface interface
Fig. 16 Fig. 17
Bond device done Device management
interface interface
Alterations which serve the technological progress as well as errors excepted!
DE EN
EN NL
DE
FR
DK
SE
Fig. 15
Scanning
interface
ORIGINAL MANUAL NORSUP 9