ALPATEC VL 28.1 Mode D'emploi page 7

notice VL 28-37-45_1-reso
ASSEMBLY OF MODELS VL 37.1 AND VL 45.1
1. Front guard
2. Guard securing clips
3. Spinner lock nut
4. Fan blade
5. Guard lock nut6. Rear guard
7. Shaft pin
8. Location pins
9. Motor shaft
A. Remove the spinner lock nut (3) and guard lock nut (5) from the motor shaft spindle (9).
B. Fit the rear guard (6) by positioning on location pins (8). Secure the guard to the motor body with the
guard lock nut (5).
C. Push the fan blade (4) onto the motor shaft (9) by matching the slots on the base of the blade with the
shaft pin (7). Secure the blade with the spinner lock nut (3). The spinner lock nut (3) must be tightened by
turning it in an anti-clockwise direction. Check that the fan blade (4) rotates freely by turning with your
hand.
D. Open the securing clip at the bottom of the front guard (1) and loosen the clip screw. Position the top
clip on the uppermost part of the rear guard (6). Push the top clip down and press the rim of the front
guard (1) onto the rear guard (6). Close the bottom clip and tighten the screw.
ASSEMBLY OF THE STAND
1. Stand
2. Base plate
3. Main cord
4. Fixing ring
A. Remove the fixing ring (4) from the bottom of the stand (2).
B. Put the main cord (3) through the hole on the base plate (2), and fit the
stand onto the hole.
C. Pass the fixing ring (4) through the main cord and screw it on the stand tightly as shown.
SPEEDS
Turn the ring switch to control the air flow.
0
VL 28.0 Off
VL 37.0, VL 45.0 Off
10/02/06 11:09
II III
Low High
Low Medium High
Page 7
1 2 3 4 5 6
VL 28.1
7
9
8
7
1
4
2
3
VL 37.1 - VL 45.1