Maintenance - Livoo DOM416 Manuel D'utilisation

Operation
• The setting temperature can not be adjusted.
• Do not install the exhaust duct to the window.
Timer opearation mode
• When the air conditionner is Off, press Timer button to activate the unit and set Off timer, the Off
indicator light illuminates.
• Press buttons (+) and (-) to set Off timer or On time
• With the unit on, press this button to set off timer.
• With the unit off, press this button to set on timer.
Mode de fonctionnement Veille
• Press this button to enter sleep mode, which the unit will exit after 6 hours of continuous operation
and restore to the previous status.
• The temperature will increase from 1°C after 60 minutes and 2°C after 120 minutes.
Drain water
• During dehumidifying mode, remove the upper drain plug from the back of the unit. Attach the
drain hose to the hole. Place the other end of the hose in the drainage way or other drain areas.
• If the unit you bought has the pump drain outlet, as shown below, please drain in this way :
Remove the pump drain plug from the back of the unit, attach the drain hose to the hole. Place
the other end of the hose in the drainage way or other drain areas.
• When the water level of the bottom tray reaches predetermined level, the digital display rea
shows "E4"and the WATER FULL indicator light illuminates. Carefully move the unit to a drain
location, remove the bottom drain plug and let the water drain away. Reinstall the bottom drain
plug and restart the machine until the E4 symbol disappears. If the error repeats, call for service.

MAINTENANCE

WARNING
• Before the cleaning of the air conditioner, it must be shut down and the electricity must
be cut off for more than 5 minutes, otherwise there might be the risk of electric shocks.
• Do not use gasoline, benzene, thinner or any other chemicals, or any liquid insecticide
on the air coniditioner, as these substances may cause flaking off of the paint, cracking
or deformation of plastic parts.
• Never attempt to clean the unit by pouring water directly over any of the surface
areas, as this will cause deterioration of electrical components and wirting insulation.
EN 37