CARPOINT 02.600.61 Mode D'emploi page 6

2. Determine the position of the LED indicator and the reset switch. Attach both and conduct the wires to
the brain unit.
3. Determine the position of the shock sensor, microwave sensor and the ultrasonic sensor and conduct
the wires to the brain unit.
4. Find a good mass (-) and connect the black wire (of the 12-pole plug) to it.
5. Find a constant plus (+12V) min. 15Amp and connect the red wire (of the 12-pole plug) to it.
6. Place the siren and connect the mass. Conduct the wire (+) to the brain unit en connect it to the pink
wire (of the 12-pole plug).
7. Find the left and right feed wire of the flashlights. Connect these wires to the brown wire (of the 12-pole
plug) 2 x (1 x left, 1 x right).
8. Find a ACC plus (+12V) when the key is in the ACC On position and connect the white wire (of the 6-pole
plug) to it.
9. Couple the plugs. First the 12-pole plug, then the 4/3-pole plug (shock, ultrasonic and microwave sensor),
then the 6-pole plug, then the 2-pole plug (LED indicator and reset switch).
INSTALLING CENTRAL DOOR LOCKING SYSTEM
1. The car has a central door locking system. Please judge if it is a negative or positive trigger.
2. The car has a central door locking system, but the command door does not have a motor (the other three
have motor). As long as the command door gets a motor installed it can work. See picture 4 for reference.
3. The car has a pneumatic central door locking system and it has a pneumatic and electric lock option. Connect
the wire to input of the pneumatic lock to activate it. See picture 5 for reference.
4. If the car does not have a central door locking system, please install one. See picture 2 for reference.
TROUBLESHOOTING
A. After the brain unit is placed in the car, the siren sounds nonstop and can not be stopped by the transmitter:
1) Check the socket connections.
2) Check the wire connections.
3) Check the switch connections.
4) Check if the fuse is broken.
5) Check if the codes between the transmitter and the brain unit match.
B. The alarm is triggered when the car is parked and armed when a heavy truck passed:
1) Check whether the sensitivity of the shock sensor is too high.
2) Check the wires between the brain unit and the siren.
3) Check the battery and the voltage with a voltmeter.
C. When armed the siren goes within 10 seconds:
1) Check the shock sensor.
2) Check the LED indicator of the shock sensor.
3) Check the wire connections, especially the brake light and illumination light.
4) Check the pin switches.
D. The central lock system doesn't work normally:
1) Check the actuators.
2) Check the wire connections and fuse. If the fuse is broken there must be an installation problem.