infaco Electrocoup DSES F3015 Notice D'utilisation page 17

Checking that the system is operating correctly
9
12
Check every day that the DSES system is working correctly. To do this :
1- Switch on your pruning shear by pressing the button no. 10.
2- Check that pruning shears is not indicating a fault (If the led no. 9 is red and that
the Data base indicates a fault D07, see the "DSES fault indication" box below).
3- With the glove no. 8, flat down without the hand inside, come in contact with
the pruning shear hook. The blade must open or not close when the trigger no. 12 is
operated.
DO NOT FOR ANY REASONS, TEST THE GLOVE WITH THE HAND
INSIDE
If the DSES system is working correctly, the pruning shear should not close in any
circumstances
As well as carrying out daily checks, you should also carry out visual checks to ensure
that the conductive glove is in good overall condition. It is also necessary to machine-
wash the conductive glove (max. 30°) once a week in order to maintain optimum
conductivity.
Replace the glove(s) if worn.
10
17
8