PAW SR5 Instructions De Montage page 5

2 Assembly and installation [specialist]
2.2 Actuator as an accessory
Fig. 1
Selector
switch
Fig. 2
blue
Fig. 3
Fig. 4
2017/11
Stop bolt
99705xx-inf-ml – V01
Assembly of the actuator for mixing valve
with flow on the right:
If the PAW actuator has been purchased as an
optional accessory, the mixing valve contains a
metal plate. To mount the PAW actuator on the
mixing valve, proceed as follows:
1. Turn the rotary knob of the mixing valve
into position 0 (fig. 3).
2. Set the actuator to manual mode
by turning the selector switch (fig. 1).
3. Turn the rotary knob of the actuator to
the left to the position shown on the
adjacent figure (fig. 2).
4. Mount the rotation lock / the stop bolt in
the left opening of the metal plate (fig. 3).
The actuator is fixed on a stop bolt.
5. Put the PAW actuator on the rotary knob
of the mixing valve and mount the actuator
on the stop bolt.
6. The PAW actuator must be mounted in a
horizontal position as shown in figure 4.
7. Set the actuator to automatic mode.
5