Euro-saime ANSONIC VF 950A Mode D'emploi page 57

MAIN MACHINE FUNCTIONS
Happy
1 Muy Sucio 5 Colores Delicados 9 Prelavado Delicado
2 Suciedad Normal 6 Enjuague Fuerte 10 Sinteticos
3 Poca Suciedad 7 Tratamiento Especial 11 Colores Delicados
4 Colores Firmes 8 Centrifugado 12 Enjuague Delicado
DESCRIPTION OF FUNCTIONS
▼ ON/OFF KNOB OR BUTTON
To start the machine, pull programmer knob or if the machine has push-button,
OFF
ON
press the start push-button .
The indicator light will be illuminated.
▼ NO-DRAIN BUTTON:
0
When this button is pushed, the washing machine will stop automatically at the end
1
of the last rinse cycle and before draining the water. In this case, the washing is
held in the water-filled drum to prevent creasing. This function only works for the
delicate wash cycle.
▼ NO-SPIN BUTTON:
0 Pushing this button the washing machine carries out a normal wash cycle but does
1
not spin.
▼ HALF-LOAD BUTTON:
Pressing this button reduces the quantity of water used during the wash, thus saving
0
1/2
1
both water and energy.
Use this function when the quantity of items to wash is equal to half the maximum
recommended load (see table "Maximum recommended loads")
▼ EXTRA RINSE BUTTON:
The washing machine has been designed to reduce water consumption to a minimum.
0
1 Three rinse cycles are normally sufficient. For very soft water zones or for those
who are allergic to detergent residues, press this button and the machine will carry
out an extra rinse.
▼ 550/MAX SPIN SPEED BUTTON:
Push the button to vary the speed of the spin-dryer from maximum to minimum (the
MAX
spin-dryer's maximum speed varies depending on the model). If the machine has
550
a speed adjustment knob, rotate until the desired speed is reached.
Warning: This is only available during intensive wash programmes. For delicates and wool,
the spin speed is 550 rpm regardless of the speed setting.
TEMPERATURE LIMIT BUTTON:
▼
Pushing this button will limit the temperature to 60° when the temperature dial is
0
set at a higher temperature.
1
TEMPERATURE CONTROL(according to the model)
▼
Rotate this knob to set the required temperature.
In order to select the correct wash temperature, refer to the "Programme Table".
Important: programme changes or the selection of the above functions must always be
carried out with the appliance switched off.
VF - 950 A
OFF
VF 950 A E
40
ON
13 Tratamiento Especial
50 580
14 Centrifugado 30
15 Lana
16 Tratamiento Especial
°C 60 550
90
900
70
80
A Table of programmes
B Buttons
S Machine "on" indicator light
Stop
620
16 1 2 3
4
650
5
T Thermostat dial
15
Stop
6
14
690
13
P Programmer dial
12
11
720
7
10
8
9 Stop
760
V Spin control dial
(Available according to the model)
SM1381
GB