LENCO PBA-830 Mode D'emploi page 9

•Depending on which charging capacity you would like, plug the USB connector of the charging cable supplied into either
the outlet OUT 5V/1A or OUT 5V/2.4A on the spare battery. Connect the micro USB plug to your mobile device.
If your mobile device has a mini USB or an Apple® Lightning connection, use the appropriate adapter provided.
It begins to charge automatically.
•If the device does not automatically begin to charge, briefly press the On/Off switch
activate charging.
The blue indicator lights on the charging display show the current capacity of the battery while it is charging (P=20% - O
=40% - W=60% - E=80% - R=100%):
•Indicator light lights up - capacity still remaining
•Indicator light is off - already empty
If all five indicator lights are off, the spare battery is completely empty and must be charged up again before the next use.
The spare battery switches itself off automatically once the mobile device connected to it is fully charged.
•If you want to stop charging before the mobile device is fully charged, briefly press the On/Off button on the spare
battery twice until the indicator lights go out, and then remove the charging cable from the device.
•After disconnecting the mobile device from the spare battery, the indicator lights of the spare battery will flash or light
up for approx. 30 seconds.
•If you connect mobile devices with a power consumption of less than 85 mA to be charged, the spare battery will
switch itself off automatically after a short time because it does not recognise the device - see section
"Problems/solutions".
09
on the side of the spare battery to
EN
NL
DE
FR
ES