Power Management - Ariens 986054 AR905011 Série Manuel D'utilisation

Example:
Tool or Appliance
Quartz Work Light
(1000 Watt)
Drill (1/2 inch,
5.4 amps)
Airless Sprayer
(1/3 HP)
Radio
Fan
2460 Total
Running Watts
Total Running Watts
Highest Starting Watts
Total Starting Watts Needed

POWER MANAGEMENT

To prolong the life of the generator and attached devices,
it is important to take care when adding electrical loads to
the generator. There should be nothing connected to the
generator outlets before starting its engine. The correct and
safe way to manage generator power is to sequentially add
loads as follows:
1. With nothing connected to the generator, start the engine
as described later in this manual.
2. Plug in and turn on the first load, preferably the largest
load you have.
3. Permit the generator output to stabilize (engine runs
smoothly and attached device operates properly).
ELECTRICAL
Running Additional
Watts* Starting Watts*
1000 0
600 900
600 1200
200 0
60 200
1200 Highest
Starting Watts
2460
+ 1200
3660
4. Plug in and turn on the next load.
5. Again, permit the generator to stabilize.
6. Repeat steps 4 and 5 for each additional load.
Never add more loads than the generator capacity. Take
special care to consider surge loads in generator capacity
as previously described.
NOTICE:
Do not overload the generator's capacity. Exceeding the
generator's wattage/amperage capacity may damage the
generator and/or electrical devices connected to it.
Tool or Appliance
DIY/Job Site
Quartz Work Light (1000 Watt)
Circular Saw (Heavy Duty, 7
1/4")
Drill (1/2 inch, 5.4 amps)
Miter Saw (10")
Battery Charger (15 amp)
Reciprocating Saw
Air Compressor (1 HP)
Demolition hammer
Airless Sprayer (1/3 hp)
Radio
Fan (20" Box Fan)
*Wattages listed are approximate. Check tool or equipment for actual wattage.
9 — English
Estimated* Estimated*
Running Additional
Watts Starting Watts
1000 0
1400 2300
600 900
1800 1800
380 0
960 960
1600 4500
1260 1260
600 1200
200 0
60 200