Volfoni ACTIVHUB RF50 Manuel D'utilisation page 10

2. IR > RF mode
1. Set the function selector to position 8.
2. Plug the USB connector to a powered socket or an
optional adapter.
3. Plug the micro-USB connector to the ActivHub
4. Check the blue LEDs light up to signal power on.
5. Turn the IR reception window towards the IR 3D source
like the 3DTV.
6. Check the blue LEDs starts blinking twice every 3 sec.
7. Make sure you keep the IR reception window turned
toward the 3D source.
Notes:
• The ActivHub
signals 3D sync input and its RF transmission.
• IR receiving mode requires a clear line-of-sight
between the ActivHub
• If you experience interferences, or if you are using
many ActivHub
may choose another channel between 3 and E.
3. DLP®-link™ > RF mode
1. Set the function selector to position 8.
2. Plug the USB connector to a powered socket or an
optional adapter.
3. Plug the micro-USB connector to the ActivHub
4. Check the blue LEDs light up to signal power on.
5. Turn the DLP-link reception window towards the screen
or the projector.
6. Check the blue LEDs starts blinking twice every 3 sec.
7. Make sure you keep the DLP-link
turned toward the 3D image or source.
10
RF50 blinking twice means a functional
TM
RF50 and the 3D source.
TM
RF50 in a single room or building, you
TM
reception window
TM
RF50.
TM
RF50.
TM