Safety Instructions; Mounting Instructions - DURAVIT 792803 00 0 00 0000 Notice De Montage

Intended use
The sealing set is used to seal and noise-proof DuraSolid
shower trays when installed flush with the floor.
Target readership and qualifications
The sealing set may only be installed by a qualified
plumber.
Explanation of the symbols
Link to the mounting instructions in this section
> Action required

Safety instructions

Product and/or property damage
The breach of local and country-specific regulations
and standards can cause damage to the product and/or
property damage.
> Observe the local installation regulations and any
country-specific standards at all times.
Product or material damage due to
NOTICE
no seal.
> A compound seal is absolutely essential behind and
below the shower tray. The planner must include this
across all trades.
> The sealing set # 792803 is only to be used to create a
second sealing level.
Notes on storage and handling
• Store in a dry, dust-free location.
• Storage temperature + 5°C to + 40°C
• Protect from UV radiation.
• Handle batch sealing strips in complete strips.
• NEVER combine and process several sealing strips.

Mounting instructions

The mounting instructions are used to assemble the
sealing set. There are separate mounting instructions for
assembling the shower tray.
1
Prepare sealing set and installation site
> Select the processing temperature between + 10°C
and + 40°C.
> Remove dust, grease and condensed water from
bath edge.
> Ensure that the walls are smooth, load-bearing
and free of dust, dirt and sharp-edged items.
> Select the base, e.g. plasterboard or gypsum
fibreboard, lightweight cement plates or smooth
plastered walls.
> Pre-treat the wall and floor surfaces to which
the bath sealing strip is to be attached with an
adhesive base/primer suitable for the base and
the compound seal that is then to be applied.
In the event of doubt ask the supplier of the
compound seal which adhesive base/primer
should be used for the compound sealing system.
2 34
+ Apply compound seal
> Comply with the manufacturer's information
for the application and drying time of the
compound seal.
6
Note tile depth
> Measure tile depth. The tile adhesive is already
taken into account in the calculation at a depth of
2 mm.
> Select appropriate distancers.
36
Using silicone without acetic acid
> Use alkoxy-based silicone.
57357_ZU_M_Waterproofing set_DuraSolid shower tray/19.08.4
5