Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Press the unit charge indicator button; at least 3 LEDs should illuminate before
attempting to jump start a vehicle.
•
Connect the RED clamp to the vehicles positive (+) battery terminal.
•
Connect the BLACK clamp to the vehicles negative (-) battery terminal.
•
Firmly insert the blue end of the jumper cable into the jump start socket of the
battery unit.
•
Turn the vehicle ignition switch and start the vehicle. Leave the vehicle running to
continue charging the battery.
•
When the vehicle is started, disconnect the blue end of the jumper cable from the
battery unit.
•
Disconnect the red and black clamps from the vehicle battery terminals.
CHARGING OTHER DEVICES
After connecting auxiliary power cables, press the indicator light switch if charging
doesn't begin.
USB-POWERED DEVICES
Plug a USB cable or use the provided adaptor cable to the USB 5V 2A output port.
Note: certain tablets, large phones, and other devices may not be able to draw sufficient
power from the USB port to charge while in use. See your device manual for minimum
charging specifications.
LAPTOP POWER PORT
If your laptop uses a 16 or 19V 3.5A power adapter, select the proper voltage BEFORE
plugging in your laptop by pressing on the voltage selection button. The LCD indicator
will display the selected output voltage. Select the appropriate adapter for your laptop
and plug the cable into the battery unit.
IMPORTANT: Impecca declines any and all responsibility for damage and risk of improper
use of electrical output voltage and currents.
LED FLASH LIGHT
Press and the hexagon button on the handle to turn on the LED flash light. Press the button
again to cycle between a normal beam, strobe light, SOS signal, and finally to turn the light off.
To use the emergency lighting wings, open the wing and tilt as needed. When closed, the
lights will turn off automatically.
–4–
Publicité
Table des Matières
