Connecting Ductwork - Fulgor Milano F4OTR30S1 Guide D'installation

Masquer les pouces Voir aussi pour F4OTR30S1:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STEP 3
• Thread power cord through the hole at the bottom of the
top cabinet.
• Swing the unit upward to meet the top of the mounting
plate and hold it securely. See Figure 23.
Figure 23
STEP 4
• Insert a bolt down through each hole in the upper cabinet
bottom.
• Tighten the bolts until the gap between the upper cabinet
and microwave oven is closed. See Figure 24.
Figure 24
Installation Guide

Connecting Ductwork

• Extend the house duct down to connect to the exhaust
adapter. Seal exhaust duct joints using duct tape. See
Figure 25.
House Duct
Figure 25
How to Replace the Charcoal filter
1. Unplug the oven or turn off the power at the main power
supply.
2. Remove the grille air mounting 3 screws and open the
door. See Figure 26.
Figure 26
3. Slide the grille air to the left, then pull it straight out.
4. Push the charcoal filter backward and remove it.
EN
9

Publicité

Table des Matières
loading

Table des Matières