Perel SOL50F Mode D'emploi page 4

Only use the device for its intended purpose. Using the device in an unauthorised way will void
the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or problems.
Nor Velleman nv nor its dealers can be held responsible for any damage (extraordinary,
incidental or indirect) – of any nature (financial, physical...) arising from the possession, use or
failure of this product.
Keep this manual for future reference.
4. Connection
4.1 Tips
 Use suitable connection cables – preferably UV-resistant cables with section 2.5-4 mm² –
depending on the length of the cables and the size of the panel. We recommend using the
Velleman SOL/SPC3 cables (not included).
 Connect the negative pole of the panel to the negative pole of the charge controller (not
included). Similarly, connect the positive pole of the panel to the positive pole of the
charge controller.
4.2 General
Coat the wires and terminal posts with Vaseline

Make sure the connection box is tightly closed to prevent moisture from entering.

If the solar module is to be mounted in a coastal area, it is extra important to protect the

installation from moisture to prevent saltwater corrosion.
4.3 Schemes
Single-Panel Connection
The solar module should be connected to a battery system via a charge controller.
V. 01 – 27/04/2018
SOL50F/SOL100F
® to protect them from corrosion.
4 ©Velleman nv