Publicité
Les langues disponibles
Les langues disponibles
Preheating
You can preheat the device without any food products. In this case, turn the timer button to more than 3 minutes and wait till the time
has expired. Then fill the basket with food products and turn the timer knob to the required cooking time
Hot air frying
•
Remove the basket carefully from the device.
•
Put the food products in the baskets.
•
Slide the drawer back into the fryer by handle.
•
Determine the required cooking time and required temperature for the food products by turning the timer and
temperature knob.
•
When you hear the timer bell, the set time has elapsed. Open the drawer by pulling the handle and make sure the food
items are ready.
•
To remove the ingredients, lift the basket out of the drawer by handle(push the release button(B)).
•
Empty the basket into a bowl or onto a plate.
Maintenance
•
It is important that you clean the entire appliance after each use to prevent an accumulation of grease and avoid
unpleasant smells.
•
Let the appliance cool down and unplug for the wall outlet before cleaning.
•
Do not immerse appliance in water or wash it under running water.
•
If there is uncleaned filth on the surface or bottom of the basket, use a damp sponge with a cleaning agent to clean. Let
it soak first in the water for about 10 minutes.
•
Using a damp sponge with cleaning agent to clean the inside of fryer dry, then wipe the soap away with water and dry it
with a dry cloth.
•
Do not use abrasive cleaners or sharp items to clean the fryer, as it will scratch the fryer body.
•
Let all parts and surface dry thoroughly prior to starting or operating the fryer again.
Warranty does not cover
•
If the above points have not been observed.
•
If the appliance has not been properly maintained, if force has been used against it, or if it has been damaged in any
other way.
•
Errors or faults owing to defects in the power grid.
•
If the appliance has been repaired, modified or changed in any way or by any person not properly authorized.
•
Do not repair the power cord by yourself or don't use the product any more in case the power cord is damaged, and
please contact the appointed Service Agent or Centre immediately.
Recycling
This product bears the selective sorting symbol for waste electrical and electronic equipment This means that this
product must be handled pursuant to European Directive (2012/19/EU) in order to be recycled or dismantled to
minimize its impact on the environment. For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentially dangerous for the environment and
human heath due to the presence of hazardous substances.
Declaration of conformity
Hereby Gimeg Nederland B.V. declares that the device MA-200, applies all basic requirements and other relevant regulations listed
in the European directive for electromagnetic compatibility (2014/30/EU) and low voltage directive (2014/35/EU). If you require a full
declaration of conformity, you can contact the adress listed on the backside of this manual
ENGLISH
Publicité
