Acrohm FUSH NANO Mode D'emploi page 3

EN
6. Cycle of Light Colors: Press the button four times to turn on/off the cycle of the
colors.
*
If FUSH nano is not used for about 30 minutes, it will turn off automatically.
Light tips
Connection: When the cartridge is loaded, the blue light flashes once to prompt the
connection.
Without Pod: When the FUSH mod is not connected to the pod, it flashes green light
three times.
Short circuit prompt: When it is short-circuited or the resistance is lower than 0.9Ω, it
flashes red light three times.
Low battery prompt: When the voltage is lower than 3.3V, it flashes yellow light three
times.
Charging: The white light is on when charging, and it is off when it is full.
Note
1. If not used for a long time, please turn off the product.
2. Do not charge for a long time.
3. Do not drop, discard or abuse your product, as it may cause damage.
4. Use a standard USB output charger within appropriate current and voltage range.
5. Keep this product away from water or any flammable gases or liquids.
6. Do not expose it to direct sunlight, dust, moisture for a long time.
7. Do not expose the product to extreme temperatures. (Applicable temperature range:
-10~60°C / 14 ~ 140°F when used, 0 ~ +55°C / 32 - 131°F when charging,
-10~45°C/14~113°F when storing)
8. EEE Recycling: This product should not be disposed of as municipal solid waste and
should be delivered to a suitable collection point for electrical and electronic
equipment.
9. Battery Recycling: The battery should not be disposed of as municipal solid waste,
and should be delivered to the appropriate old battery recycling point for
recycling.
10. This product can only be repaired by ACROHM. Please do not attempt to repair it
yourself, otherwise it may cause damage to the product or personal injury.
EN