TZS First AUSTRIA FA-2410 Mode D'emploi page 2

DIGITAL ALARM CLOCK
INSTRUCTION MANUAL
CONTROLS AND INDICATORS
2.
1.
5.
1. Minute set button
2. Time set button
3. Hour set button
4. Alarm set button
5. Snooze button
6. Alarm on/off switch
7. Battery compartment
8. LED Display
9. AC power cord
10. Alarm off button
1. CONNECTING THE POWER
Insert correctly wired plug into a power outlet. The clock display will blink showing that the time is
not correct. It will also blink if there has been a power cut and no back up battery is fitted.
2. TO SET THE TIME
2.1 Press and hold the time set button (2).
2.2 Press the minute set button (1) or hour set button (3) to set the clock display to the correct
time.
2.3 Release the time set button (2).
3. TO SET THE ALARM TIME
3.1 Press and hold the alarm set button (4).
3.2 While holding the alarm set button (4) press the hour set button (3) and minute set button
(1) to advance the time until the desired alarm time is shown on the display.
NOTE: To check up the wake-up time, press the alarm set button (4). The clock display will show
the preset alarm time.
4. WAKE TO BUZZER ALARM
4.1 Set the alarm on/off switch (6) to ON position. The respective AUTO indicator will light on.
The buzzer will now be switched on automatically at the selected alarm time for 1 hour and
59 minutes.
m_2410_v05.indd 2-3
3. 4. 10. 9.
6.
7. 8.
2
4.2 Press the alarm off button (10) to turn off the buzzer, the alarm will be activated again after
24 hours.
4.3 Slide the alarm on/off switch (6) to deactivate the alarm function completely.
5. SNOOZE OPERATION
To obtain approximately 9 more minutes of sleep, press snooze set button (5) after the buzzer
works at the preset wake-up time. This will silence the buzzer for about 9 minutes.
6. BATTERY BACK UP
nOtE: The clock has a back up power system to ensure continuous operation of the alarm and
clock in the event of a power failure. The switch from AC to battery power is automatic. However,
under battery power the clock display will not illuminate even through the clock will maintain
approx. the current time and will store the alarm time in its memory. The system operates on a
9V battery (not included). We recommended the use of a long life battery to ensure maximum
performance.
nOtE: This battery back up features is intended to retain the clock time and memory functions
during a power failure for short periods. The clocks should not be left for long periods of time
without mains supply as the battery will drain fairly quickly. Remove the battery if the unit is
disconnected from the mains.
caRE: The cabinet can be dusted with soft cloth or if necessary cleaned with a soft cloth
dampened with water. The power plug should be disconnected before cleaning. Never use polish,
solvent, abrasives or strong detergents on the cabinet since these can damage the finish.
SPECIFICATIONS:
POWER SOURCE: AC 230V/50Hz
Dripping warning:
The product shall not be exposed to dripping or splashing and that no objects filled with liquids,
such as vases, shall be placed on the product.
Ventilation warning:
The normal ventilation of the product shall not be impeded for intended use.
Disconnect device warning:
"Main plug is used as connection, so it should always remain ready operate."
3
12-11-29 下午3:41