Jung eNet FM AS 10 UP Instructions D'utilisation page 9

eNet
Récepteur / Actionneur 1 voie
Switch­on delay
Switch­off delay
Run­on time
Behaviour after the end of the
disabling function
Behaviour on voltage return
82581213
J:0082581213
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
On
Off
no change
Last value
Basic setting: No change
On
Off
Last value
Configured brightness
Basic setting: Off
9/12
The load switches on after a
delay. Repeated switch­on
commands restart the delay
time. If the load has not yet
been switched on due to the
delay when a switch­off com­
mand comes, then the load
will remain off.
In Flashing operating mode,
the pause times are set using
this parameter.
Comment: The set times apply
to operation using radio trans­
mitters. The relay is switched
immediately when the Prog
button is pressed.
The load switches off after a
delay. Repeated switch­off
commands restart the delay
time. If the load has not yet
been switched off due to the
delay when a switch­on com­
mand comes, then the load
will remain on.
In Flashing operating mode,
the pulse times are set using
this parameter.
Comment: The set times apply
to operation using radio trans­
mitters. The relay is switched
immediately when the Prog
button is pressed.
As soon as a run­on time has
been entered, the actuator will
no longer remain on perma­
nently, but only for the length
of the run­on time. The run­on
time is restarted if actuation is
repeated. This parameter is di­
rectly connected to the "Ma­
nual switch­off of run­on time"
parameter.
Comment: The set times apply
to operation using radio trans­
mitters. The relay is switched
immediately when the Prog
button is pressed.
Behaviour of the output when
a block is removed.
Defines the behaviour of the
output after voltage return.
13.03.2014