Nesco PIC-14 Manuel De L'utilisateur page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Caution:
hanges or modifications not expressly approved by the party responsible for
C
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with Part 18 of the FCC
Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
consumer ISM equipment, persuant to Part 18 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residentual installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
13

Publicité

Table des Matières
loading

Table des Matières