Publicité
Les langues disponibles
Les langues disponibles
ASD-116 InstructionManual-FINAL02
Function
Power On
Power Off
Pairing
Pairing
Failed /
Timeout
Increase
Volume
Decrease
Volume
Mute
Actions
From Off state, press and hold
power button for 3 seconds
In standby, press and hold power
button for 5 seconds
1. From Off state, press and hold
power button 6 seconds
2. Perform device discovery from
console.
3. Search devices from console. It may take a few seconds to
4. Select device from console.
5. Enter pass key "0000", then
"OK" to pair the headset with
the console.
Devices not paired within
3 minutes.
Press volume + repeatedly till
desired volume level is reached.
Press volume - repeatedly till
desired volume level is reached.
+ Vol. / - Vol. press and hold 2.5
seconds.
5
4/10/10
12:54 PM
Result
Blue LED flashes 5 times; fol-
lowed by a long beep and then a
short beep. Device goes to
standby mode, Blue LED contin-
ues flashing every 2 seconds
Blue LED flashes followed by
Red LED flashes + 2 short beeps
Blue and Red LED flash alter-
nately for a maximum of 10 min-
utes; followed by a short beep
discover all devices within vicinity.
It may take a few seconds to
make connection.
The device ID is stored in the
console device listing Blue LED
flashes + 2 short beeps
No sound.
Volume increases per step; Short
beep tones when maximum vol-
ume level is reached.
Total 15 levels.
Volume decreases per step;
Short beep tones when minimum
volume level is reached.
Total 15 levels.
Beep.
Page 5
Publicité
