Listening To The Radio; Troubleshooting Guide - RCA SPS3688B Manuel De L'utilisateur

1. Press the
button, "90" is
shown and timer
LED indicator flashes.
2. To set timer from 1-99 minutes, you can
either:
a. press the
preset time. 90, 75, 60, 45, 30, 15, 10
minutes will be shown, or
b. press and hold the
fast forward/reverse the timer.
3. Once it reaches to your desired time, leave
the TIMER indicator flashes for a few
seconds, then it will turn to solid, timer is set.
1. Press the button.
2. Press or
desired station.
3. Press the or
desired volume level.
4. If you are in BT mode, press
to radio mode.
SearChIng For a StatIon
aUtomatICaLLy
• Press and hold the
the tuner starts searching for a station, then
release. After finding a clear station, the
search stops automatically.
Note: The search may not stop at a station
with a very weak signal. To improve the radio
reception, fully unwind the FM antenna wire and
place it in the position that sounds best.
Poor FM reception
• Make sure FM antenna wire is fully extended.
• Electrical interference in your kitchen may
cause poor reception. Try to install the unit
away from them (especially those with
motors and transformers).
Clock does not show the correct time
• There has been
interruption. Set the clock again.
Setting the Cooking timer
button repeatedly to select
/ buttons to

Listening to the radio

buttons to tune in to a
button to obtain the
button once
/ buttons until

troubleshooting guide

an electrical
4. When the preset time elapses, the ALARM
will sound.
5. Press the
on, the display will show the remaining time.
Note: Do not press any buttons within 5 seconds
after setting the cooking time, otherwise the
cooking timer will be cancelled.
CanCeLLIng the CooKIng tImer
• You can cancel the timer anytime by pressing
the
the LED indicator turn off.
PreSettIng StatIonS
The unit can store a total of 20 FM stations in
memory. Presetting allows you to tune in to a
station directly.
A. Presetting Stations Manually
1. Tune in to a desired station (see previous
section).
2. Press the
blink on the display.
3. Press the
select the preset number you desire.
4. Press the
memory.
5. Repeat steps 1-4 to store other stations.
B. Presetting Stations Automatically
Press and hold the
in to stations one by one and will stop until all 20
stations are preset and stored.
Bluetooth devices doesn't pair with this unit
• Make sure your Bluetooth device is working
properly.
• Reset the bluetooth connection by turning off
and on your connecting device, and this unit.
power
EN - ES - FR - 6
button any time during timer is
button until the timer shows "00" and
button. The preset number will
/ buttons repeatedly to
button again to store it in
button, the unit will tune