Oregon EG600 Manuel D'utilisation page 12

REMOVING THE ATTACHMENT
FROM THE POWERHEAD
• Stop the motor, remove the battery pack, and
engage the transportation lock-out
• Loosen the knob
• Push in the button and twist the shafts to
remove and separate the shaft
THE POWERHEAD EXTENSION (FIG. B)
WARNING: Do not use the extension with
the edger attachment.
FITTING THE HARNESS (FIG. C)
• Put on shoulder strap
• Adjust length of strap The carabiner should be
about a hand's width below operator's right hip
• Detach harness by pressing down on the
carabiner bar and pull the harness loop out of
the carabiner
12
Unpacking and Assembly
EG600 Multi-attachment