nedis ALRMPD10WT2 Mode D'emploi page 2

Introduction:
Security alarm system with built-in telephone dialer for emergency situations.
Pre-programmable telephone numbers and intercom function. Ideal for people
living alone or for other situations when help is required.
Installation:
1) Open the battery compartment and place 4x AAA batteries (for back-up)
according the right polarity. The red LED indicator will light up if the
batteries have low capacity. Replace the batteries.
2) Connect the supplied telephone cable to the unit and the two way splitter.
Connect your telephone also to the splitter. Connect the AC/DC adapter to
the unit and a wall outlet.
3) Switch on the unit with the ON/OFF switch. The red LED will flash for
15 seconds.
Note: if the unit is turned off the personal code, recorded message and stored
telephone numbers will not be lost.
ON OFF
2
ENGLISH
Telephone
wall outlet