D-Link AC1750 Guide D'installation page 3

5 GHz - When lit, the access point is operating at 5GHz.
This light will blink when there is wireless traffic.
2.4 GHz - When lit, the access point is operating at 2.4GHz. This light will blink
when there is wireless traffic.
LAN1/LAN2 - Solid light when the Ethernet port is connected to a working port,
such as a router or switch. The light will blink when there is traffic through LAN
port.
POWER - The light will blink during boot up. Once solid, the access point is ready.
Installing the Hardware
5GHz Antenna Connectors*
Reset Button
LAN Port (PoE)
LAN Port
Console Port
Power Receptor
2.4GHz Antenna Connectors*
* 1 x 5GHz and 2 x 2.4GHz antenna connectors are located on the bottom of the access point.
D-Link DAP-2695 Quick Install Guide
3