Placement And Mounting - Renkforce 2.1 Dolby Atmos Notice D'emploi

b) Placement and mounting
1. Placement
• If your TV is placed on a table, you can place the unit on the table directly in front of the TV stand, centered with
the TV screen.
• If your TV is attached to a wall, you can mount the unit on the wall directly below the TV screen.
2. Wall mounting (with wall-mounted TV)
• Installation must be carried out by qualified personnel. Incorrect assembly can result in severe personal injury and
property damage (if you intend to install this product yourself, you must check for installations such as electrical
wiring and plumbing that may be buried inside the wall). It is the installer's responsibility to verify that the wall will
safely support the total load of the unit and wall brackets.
• Additional tools (not included) are required for the installation.
• Do not overtighten the screws.
• Keep this instruction manual for future reference.
• Use an electronic stud finder to check the wall type before drilling and mounting.
WARNING
• To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation
instructions.
• Suggested wall mounting height: ≤ 1.5 meters.
1 Drill 4 parallel holes (Ø 5.5-6 mm each according to wall type) in the wall. The distance between the holes should
be 778 mm.
2 If dowels are required, place 1 dowel into each hole in the wall. Tighten the wall mount brackets on the wall with
screws and a screwdriver (not included). Make sure that they are securely installed.
3 Remove the screws on the back of the unit. Install the wall mounting screws into the back of the unit.
4 Lift the unit onto the wall mount brackets and slot it into place.
1
778 mm
2
34
778 mm
3
Remove the
screws
Install the wall
mounting screws
4
4