Buffalo GD847 Mode D'emploi page 4

Installation
Remove all packaging and dispose of it safely.
Installation work must be carried out by a qualified electrician
Incorrect wiring of this electrical device may lead to electrocution or damage to property.
The dryer must be located at least 1.8m from wet area (Zone 0).
A switch with two poles should be applied between this appliance and the power supply cable.
The appliance must be properly grounded / earthed.
Install a residual current circuit breaker (RCD)
NOTE: This appliance must not be located where it may accidently be splashed with water. ric
Electric Shock may result
Operation
1. Place hands under nozzle. The hand dryer will automatically start.
2. Hand dryer will stop when hands are removed from under nozzle or time exceeds 1 minute.
Adjusting the Automatic Sensor
The Buffalo Hand Dryer automatically detects when hands are placed under the air nozzle and will
then start automatically. The sensitivity (distance from the unit hands need to be to start Hand
Dryer) can be adjusted to suit. Adjustment of the Automatic Sensor should only be carried out by a
qualified engineer. The adjusting screw can be found by removing the front cover.
4 | P a g e