Electrical Connections - ISC HC 10 D Mode D'emploi

HC 10_D_mehrp_neu
GB
2
Dismantling the housing cover
Use a screwdriver for recessed head screws to undo
the four fastening screws.
You can then take off the housing cover.
Screw in the two upper screws size 4x20 mm as
shown in Fig. 3 to within a distance of approx. 3mm
in order to hook the unit in place. Then screw in the
lower screws and re-tighten the upper screws.
3
8
13.01.2006 10:00 Uhr Seite 8

Electrical connections

Please note that the electrical connection has to be
made by a qualified electrician in accordance with
the directives issued by your local power supply
company and with the VDE standard in force for
sauna heating equipment.
It is essential for the controller to be permanently
connected to the power supply. The customer is
responsible for installing a disconnecting device that
disconnects all poles from the power supply at a
minimum distance of 3 mm. A plastic sheathed cable
of at least duty class H07RN-F (insulation ID 245 IEC
66) has to be used for this purpose.