Tecnovita YU110 SONIXVISAGE Manuel De L'utilisateur page 25

Charge cable
1.
Control Functions
Beginning a session
• Fully charge the battery before using the appliance for the first time.
• Before beginning a session, remember to remove makeup and all accessories
such as necklaces, earrings, contact lenses, piercings, etc... Make sure your skin
is clean and dry.
• In ultrasound mode always apply an abundant amount of gel to the area and begin
to work it by slowly sliding the head over the area but without pressing, as shown
in the diagrams contained in the Application Zones section of this manual.
Before starting the LED mode remember to put on the protection glasses
If you need to purchase ultrasound gel, you can find it in the shop where you
purchased SonixVisage or at our website: www.tecnovita.eu
2.
1. ON/OFF
2. LED
3. ULTRASOUND
4. CHARGE
5. POWER
6. Level LOW
7. Level MIDDLE
8. Level HIGH
Encendido/Apagado
Active/Select LED mode
Active/Select Ultrasound
intensity
Charge indicator
Power indicator
Low intensity ultrasound
Middle intensity
ultrasound
High intensity ultrasound
25