Led Display; Learning - Beeper iVELO Manuel D'installation & D'utilisation

LED DISPLAY

The iVELO is equipped with a bill-poster LED with tactile orders. Here how to use your
bill-poster in depth.
Speed
Battery level
Total mileage
Functions

LEARNING

The iVELO has 3 using modes:
Mode 1:
Pedaling without electric assistance
Mode 2:
pedaling with electric assistance
Mode 3:
100% electric (without pedaling)
-> Note:
In mode 1 and mode 2, use only the pedals and not the manual accelerator.
1. Detail of the functions
Bluetooth connection
Alert indication
Front light indication of lighting
Low speed mode (weak battery)
2. Detail of the dysfunctions
In the event of problem on the iVELO, the picto
the bill-poster and an alarm resounds. An error code is displayed
then instead of mileage.
Err01 : Motor fault
Err02 : Right throttle lever fault
Err03 : Left brake lever fault
Err04 : Motor blocking
If one of these errors appears, please contact our engineering
service.
->
to activate the mode (L0)
Press on
-> to activate the mode (L1 or L2)
Press on
->
Use the accelerator located on the handlebar (right trigger)
ON/OFF
(long pressure 2 seconds)
Electric Assistance mode:
assistance is automatically launched when
speed reaches 2 km/h.
100% electric mode:
automatically while pressing on the right
trigger.
To slow down, apply in priority the left manual
break.
16
appears on
Err08 : Weak battery
Err10 : Bad connection
Err11 : Controller problem
The electric
The iVelo starts