Carat DPSK180000 Manuel D'utilisation page 11

3. Set the position of the Hinge
Pin on the center line of the
angle grinder.
(Fig.4 and 5)
4. Confirm the Hooks are
securely located into the groove
in the Gearbox housing.
(Fig.6 and 7)
O K
INSTALLATION
1. Hold [c] Adaptor with a downwards
pressure.
2. Tighten [n] / [o] Bolt by [p] Hex Wrench
to clamp the gearbox housing.
[n] Bolt (L60) : for BOSCH
[o] Bolt (L45) : for Others
* Make the [n] [o] Bolt head facing the
Flat Surface of [c] Adaptor.
(Fig.8)
3. Place [a] Main Body on [c] Adaptor.
4. Screw [d] Centering Holder into the
spindle of the angle grinder to fix [a] Main
Body and [c] Adaptor temporary.
5. Align the position of the Hole at [a]
Main Body and the Screw hole at Hinge
Pin of [c] Adaptor.
(Fig.9)
O K
Hinge Pin
[c]
Groove
Hook
Fig.6
[c]
Fig.4
N G
1
Fig.8
Hole
[a]
Screw hole
Spindle
N G
Flat Surface
2
[n] : for BOSCH
[o] : for Others
Fig.5
Fig.7
[p]
[d]
[c]
Fig.9
-11-